NTP 143 — Replace an I-020E-B, I-020E-H, or I-020G-F indoor ONT
NTP 143-4 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
7 If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP 134 for more information about
fiber optic handling, inspection, and cleaning.
8 Make the fiber optic connection as shown in Figure NTP 143-1.
9 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
10 Activate and test the services (DLP 128).
11 STOP. This procedure is complete.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
To Next Page
Loading...
