64 Rockwell Automation Publication 750-UM006C-EN-P - March 2022
Chapter 4 Configure and Start Up the Drive
2. Select the drive IP address that you want to import into the Logix
PowerFlex 755 Device Definition and click Continue.
While the Logix Designer application imports the drive information, it
shows a status bar, which indicates the progress.
3. Review the uploaded information on the status dialog box and make any
necessary changes.
4. Click Continue to finish the upload.
5. See Verif y Drive Data
on page 66 to confirm that the data was properly
imported.
Enter the Information Manually
1. On the Overview page, click the Device Definition dialog box.
2. On the Device Definitions dialog box, select the Drive Rating.
IMPORTANT Manual entry of the information should only be performed by an expert.
To Next Page
Loading...
Need help?
General
