Rockwell Automation Publication 750-UM006C-EN-P - March 2022 73
Configure and Start Up the Drive Chapter 4
each step in the Startup Wizard, click Next to accept the configuration and
move to the next step
.
1. On the Overview page, choose the Wizards page.
2. Click Start to run the PowerFlex 755 Startup Wizard.
3. Click Next until you advance to the Ethernet Port step.
4. On the Ethernet Port step, change Idle fault action from Fault to Stop
(adjust this setting to the most appropriate setting for your application).
Click Next.
TIP The system is currently offline from both the Logix Designer application and
the drive.
To Next Page
Loading...
Need help?
General
