AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
45
Port Use this parameter to specify the port number for
SNMP. The range is 1 to 65535. The default is
161.
Restrict the
Source of
SNMP
Requests
Use this option to increase the security of the
access point by restricting the use of SNMP to
specific subnets or individual workstations. The
options are described here:
- Enabled: Check this option to restrict the use of
SNMP on the access point to only those
management stations specified in the next field
in the window.
- Disabled: Check this option to disable this
feature and permit any workstation to use the
community string to view the unit. This is the
default setting.
Only allow
from the
designated
hosts or
subnets
Use this field to identify the management
workstations permitted to use SNMP to view the
device. This field only applies if you select the
Enabled option in the previous field. Here are the
guidelines:
- You can specify only one value in the field.
- You can specify a specific workstation by its IP
address (for example,149.23.45.102).
- You can specify a subnet by including the
subnet mask (for example, 67.101.4.0/24).
- You can specify a workstation by its FQDN.
- The default is blank.
Observe these guidelines when using an FQDN
to identify the workstation:
- It cannot start or end with a hyphen.
- Domain labels can have a maximum of 63
characters.
- An FQDN can have up to 253 characters.
System
Name
Specify the SNMP system name of the access
point. The default is either AT-TQ5403 or
AT-TQm5403.
Table 6. SNMP Agent Settings Window (Continued)
Field Description
To Next Page
Loading...
Need help?
General
