EasyManuals Logo

Analytik Jena multi EA 4000 User Manual

Default Icon
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
Transport and storage
multi EA 4000 Version 01.16 139
3. Place the white adjustment aid into the boat
position to be adjusted on the rack (here
position 37).
4. Select the option POSITION 1 from the list
and click on [A
DJUST POSITION]. The sam-
pler arm moves above the left-hand boat
position.
5. Check that the gripper is centered above
the opening of the adjustment aid and can
enter the opening without obstruction. Cor-
rect the alignment in the x and y directions
using the arrow keys where necessary.
For rough adjustment select a z value of
350, for the fine adjustment values from
450-560. This prevents the gripper from
impacting hard with the sampler.
Check the changes by clicking on [A
DJUST
POSITION].
6. Adjust the lowering depth of the gripper.
Click again on [A
DJUST POSITION] and re-
move the adjustment aid during the return
of the sampler arm to the start position.
7. Using the slider H
IGHER / LOWER adjust the
lowering depth of the gripper and set the
new position by clicking on [A
DJUST
POSITION].
8. Repeat the process until the gripper is posi-
tioned just a few millimeters below the boat
storage.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Analytik Jena multi EA 4000 and is the answer not in the manual?

Analytik Jena multi EA 4000 Specifications

General IconGeneral
BrandAnalytik Jena
Modelmulti EA 4000
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals