Anilam Wizard 900 - Page 140

134
Select Axis for Recall – F 63
F 63 allows you to specify which axis dimensions the DRO recalls from the Electronic
Notepad when you press the RCL key. You can recall dimensions for all axes or for one
or more specific axes.
To select axis dimensions for recall:
1. Press
The DRO displays the following in the message window and axis displays:
on
on
on
Axis
rcl
2. Press the desired axis key(s) to toggle the axis recall ON or OFF.
3. Press
The DRO will update only the axis dimensions set to ON when you recall from the
Electronic Notepad.