183
Troubleshooting
This section lists problems that could arise with the DRO, and provides possible
solutions to correct these problems.
Symptom
q Axis display does not illuminate.
q When you move any axis, the
displays do not update.
q When you press a key, the beeper
does not sound.
Solution
1. Check that the power cord is properly
connected and the DRO is turned on.
2. Check the AC voltage where the
power cord is connected.
3. If all of the above are checked and
OK, contact your local distributor or
ANILAM Customer Services.
1. Check that the linear encoders are
properly connected.
2. Run the system diagnostic tests
(F 45).
3 If the DRO fails the diagnostics tests,
contact your local distributor or
ANILAM Customer Services.
4. If the DRO passes the diagnostics
tests, turn on Linear Encoder Error
Check (F 41).
5. Move the axis that is not updating.
6. If the DRO displays ERROR in the axis
display, contact your local distributor
or ANILAM Customer Services.
1. Verify that the Beeper (F 21) is
enabled.
2. If the Beeper is enabled, but still does
not sound, contact your local
distributor or ANILAM Customer
Services.
To Next Page
Loading...
