iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 100 of 138
8.2 Powering the Mainframe Off
1. Check whether the iPAM400 application is
running, by observing the processor LED on
the mainframe front panel:
• flashing slowly: the iPAM400 application
is running, then shut it down by briefly
pressing the Reset/Shut Down button on
the front panel.
• flashing fast: the iPAM400 application is
not responding, then proceed to the next
step.
!
!
For iPAM400 with amplifier frame
firmware version older than V1.1.0206
the flashing indication is the opposite
way around.
2. Turn off the mainframe AC mains and battery
isolation switches.
(Front panel removed)
BATTERY AND AC MAINS ISOLATION
SWITCHES: OFF
!
!
O
I
RESET/SHUT DOWN BUTTON
processor
To Next Page
Loading...
