iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 84 of 138
6.3.1.10 Clearing the Amplifier Mainframe Configuration
!
!
This option clears the Amplifier Mainframe configuration completely, disabling the
communication between the amplifier motherboard and the controller. Consequently, the
iPAM400 stops working.
A manual configuration of the Amplifier Mainframe will be required if its configuration is
cleared. Refer to ASL for instructions.
To Clear the Amplifier Mainframe Configuration:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section “6.2 Connecting to
the iPAM400” (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the “X400” from the main menu by entering “7”.
3. Choose the “Clear configuration” from the main menu by entering “1”.
4. The Amplifier Mainframe configuration will be cleared completely.
To Next Page
Loading...
