iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 75 of 138
6.3.1.5 Playing Test Tones and Test Messages
The Setup Tool enables the user to play test tones and test messages to the iPAM400’s local outputs. It also
enables the user to play test messages to any of the zones configured on the iPAM400, which may be on
local outputs or be on other VIPA units elsewhere on the network.
6.3.1.5.1 Playing a 1 kHz Test Tone to an iPAM400 Local Output
This option will cause the iPAM400 to play a 1 kHz test tone to one of its own local outputs for
approximately 30 seconds.
To Play a 1 kHz Test Tone to an Output for 30 Seconds:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section “6.2 Connecting to
the iPAM400” (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the “Test” from the main menu by entering “5”.
3. Choose the “Play 1k tone” from the test menu by entering “1”.
A list of local outputs will be shown.
4. Choose the required output by entering its option number.
5. The 1 kHz test tone will be played for approximately 30 seconds to the chosen output, and then the
current menu options will be shown for further selections.
It is not possible to terminate the test before it completes its cycle (30 seconds).
6. If no further tasks are to be performed, then return to the main menu (if not already done) and enter
“X” to exit the Setup Tool.
To Next Page
Loading...
