iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 77 of 138
6.3.1.5.3 Playing a 1 kHz Tone and Pink Noise to an iPAM400 Local Output
This option will cause the iPAM400 to play a 1 kHz test tone followed by pink noise to one of its local outputs
in a continuous repeating loop.
To Play 1 kHz Test Tone and Pink Noise in a Continuous Repeating Loop to an Output:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section “6.2 Connecting to
the iPAM400” (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the “Test” option from the main menu by entering “5”.
3. Choose the “Play 1k/pink test” from the test menu by entering “3”.
A list of local outputs will be shown.
4. Choose the required output by entering its option number.
5. A 1 kHz test tone followed by a pink noise will be played to the chosen output in a continuous
repeating loop.
6. To terminate the test, press ENTER.
The current menu options will be shown for further selections.
7. If no further tasks are to be performed, then return to the main menu (if not already done) and enter
“X” to exit the Setup Tool.
To Next Page
Loading...
Need help?
General
