iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 65 of 138
6.3.1.1 Getting the Software Build Version
It is important to know the software build version for maintenance purposes. The software build version
should be quoted in all enquiries regarding the unit.
To Get the Installed Software Build Version:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section “6.2 Connecting to
the iPAM400” (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the “Get software version” option from the main menu by entering “1”.
3. The VIPA software build version will be shown.
4. The current menu options will be displayed for further selections.
5. If no further tasks are to be performed, then return to the main menu (if not already done) and enter
“X” to exit the Setup Tool.
To Next Page
Loading...
