iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 131 of 138
12.9 Unpacking and Handling
The equipment should be unpacked and
inspected immediately on receipt. If damage has
occurred please advise your carrier or supplier.
!
!
This equipment contains electronic
devices that are sensitive to
electrostatic discharge. Please take
precautions to avoid damage to the
electronics by static electricity.
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
Ensure that the name and address of the
Authorised Distributor from whom you purchased
the unit is recorded on the “Service and
Warranty” page of this manual for future
reference.
12.10 Packing for Return for
Repair
!
!
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage.
!
!
The filler material used for packing
for return for repair must be
antistatic or static dissipative, as this
may come into contact with exposed
connectors, wiring, or PCB
assemblies. The use of non-
conductive filler material may cause
damage to the electronic assemblies
reducing their operational life, or
even destroying them.
Advice on packing the product for return can be
provided by ASL.
To Next Page
Loading...
