ASL INTERCOM iPAM400 User Manual

iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 107 of 138
8.10 Amplifier Module Replacement
An amplifier module can be replaced with another module of the same type as described in the following
procedure.
Replacing an Amplifier Module:
1. Remove the iPAM400 front panel; see Section “8.1 Removing the Front Panel” (page 99).
2. Power the mainframe off; see Section “8.2 Powering the Mainframe Off” (page 100).
3. Remove the required amplifier; see Section “8.3 Removing an Amplifier Module from the Mainframe”
(page 101).
4. If the amplifier module is to be returned to ASL for repair or service, then it should be properly
packed to prevent physical and ESD damage.
Advice on packing the product for return can be provided by ASL.
5. Insert the new amplifier module; see Section “8.4 Installing an Amplifier Module into the Mainframe”
(page 102).
6. Power the mainframe on; see Section “8.5 Powering the Mainframe On” (page 103).
7. Re-fit the front panel; see Section “8.6 Powering the Mainframe On” (page 104).

ASL INTERCOM iPAM400 Specifications

General

Brand	ASL INTERCOM
Model	iPAM400
Category	Amplifier
Language	English