iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 85 of 138
6.3.1.11 Rebooting the iPAM400
This option causes the iPAM400 to soft reboot itself, i.e. to restart the iPAM400 under software control,
without removing power.
To Reboot the iPAM400:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section “6.2 Connecting to
the iPAM400” (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the “Reboot” from the main menu by entering “8”.
3. The iPAM400 will orderly shut down and restart automatically.
To Next Page
Loading...
