Atlas Copco FOCUS 61

Settings Focus 61 User Guide
9839 0211 01 Edition 2.0 100 (118)
12.3 Configuring Network Adapters
The Network Adapters menu (located in the Device Files
area) configures the Ethernet Ports A and B.
NOTE: It is MANDATORY to connect the Focus
61 with ToolsTalk BLM before configuring the
Network Adapters.
To configure the Ethernet Ports A and B, do the following:
1. In the Device Files area, browse Network Adapters. Then click
either ETH_A or ETH_B (depending on customer needs).
2. In the Ethernet Properties dialog box, configure the Network
Parameters (IP Address, Netmask, Gateway) and select/clear
the DHCP Enabled check box. Then click Save.