6. After configuring the event condition(s), in the lower-right corner of the Setup of external dialog
box, click Save.
To configure the signals generated by the Stacklight If the behaviour of the digital output is related to an
AOP control:
1. In the Digital output section, select the Mounted check box.
2. Below the Setup button, select the AOP control check box.
3. Below the AOP control check box, click Set relay.
4. In the Set AOP relay for external dialog box, select a relay from the drop down list.
5. On the lower-right corner of the Set AOP relay for external dialog box, click Save.
6.6.2 Adding a I/O Expander sealed
To add an I/O Expander Sealed to the Focus 61, do the following:
1. In the Device Files area, right-click I/O Accessories. Then click Add I/O Expander sealed.
2. In the Module area of the New Accessory dialog box, in the S/N drop down list, select the serial
number of the I/O Expander sealed to configure.
3. From the Event Action drop down list in the Input section, select an event that generate an input
signal on the I/O expander sealed channel. Then select an Active parameters.
If Multi-Action option is selected: click the Multi-Action button ( ). Then in the I/O
expander sealed - Multi-Action dialog box, select the Event action check box to use and the
Action Parameters. Multi-selection for the Event Action is allowed.
4. From the Event Condition drop down list in the Output section, select an event that generate an
input signal on the I/O expander sealed channel. Then, configure the following parameters:
• Event timer: select the event to configure the timer. The available options are: To next
tight and Time.
• Time: set the duration in second of the output signal. It is available if Event timer is set to
Time.
• Flash: select On to enable the flashes of the I/O Expander sealed LED.
• Period: set the time in second taken by the signal to complete on-off cycle.
• Duty Cycle: set the percentage of one period in which the signal is active.
To Next Page
Loading...
