Focus 61 User Guide Programming Focus 61
65 (118) 9839 0211 01 Edition 2.0
6.5 Identifier for multibarcode reading
The Identifier interface gives additional fields to configure up to 2 additional conditions to start a Job.
Configure a Job identifier type as identifier to start a Job. In case of Job free order, configure Step
identifiers type to allow the operator to select the steps (wrench) inside the job.
If further conditions are needed to start the Job (for example operator identifier, part identifier…), it is possible
to add additional identifier strings (up to 2) to configure the Job start (First and Second Job condition).
To Next Page
Loading...
