Focus 61 User Guide Executing tightening operations
81 (118) 9839 0211 01 Edition 2.0
7 EXECUTING TIGHTENING OPERATIONS
NOTE: No effects resulting from special conditions should be detected when the Focus 61 is
integrated into systems.
Once configured the Focus 61 Controller (as described in the previous paragraph Programming Focus
61), it is possible to start a Job on the Station(s).
On each station, only one MWR can work at the same time.
The Job associated with each MWR starts depending on the Identifier / Event settings.
To execute a tightening operation, do the following:
1. Start the Event.
2. The MWR is ready to be used: after the blue LED of the MWR starts blinking, do the tightening.
NOTE: Refer to the paragraph Associating the MWR with Station(s) for further details about the
LED indication on the MWRA.
The tightening results are visible on the Focus 61
display and on the Stacklight, if configured (see
the figure on the right).
To Next Page
Loading...
