Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 62 (118)
6.4 Configuring Job
The Job is a set of tightening operations (steps) performed by the MWR associated with a group.
NOTE: When a Job linked to a group starts, the job is sent to all the wrenches of the group. The
Job can be done by using one or more wrenches of the same group.
Each Group must be configured with its Pset as described in the paragraph above.
Double-click Add Job (see the figure above) to create a new Job.
To remove a Job either double-click and select Delete or drag the Job to the trash bin.
The Job Settings area configures the Job depending on the following parameters:
• Job Id
Progressive identifier of the Job: this is automatically given.
• Station
Station associated with the Job: this is automatically given.
To Next Page
Loading...
