Atlas Copco FOCUS 61

Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 68 (118)
• Length:dentifier length.
• Significant Positions: positions in the identifier string which must match to consider as valid a
scanned/received string.
• Significant Strings: definition of the string content linked to a job. When an identifier is received from
a source (barcode or Open protocol interface), a check will be done on the barcode/Identifier length
and on the content in the significant positions by the controller.
NOTE: If two Input sources with the same Length different from zero are configured, the
following error message is displayed: The selected pattern is in conflict
with a previously added one.
6.5.2 Configuring identifier to abort Jobs
Abort Jobs section allows to set the signal that stops a Job.
Define the following parameters:
• Input Source: select the signal between the following options:
o Barcode → barcode reader
o AOP_SETVIN→ Open Protocol via set VIN message (MID 0050)
o AOP_SETIDENTIFIER → Open Protocol via set Identifier message (MID 0150)
• Length: number of the characters of the input signal (barcode or AOP)
• Significant Position: position of the characters that builds the substring that starts the Job
• Significant String: click Set Strings; the Identifier Job Type String Setup dialog box is displayed.
From the Job drop down list box, select the Job to be used. In the end of the list box it’s also available
to be used the Abort All jobs function. This function allow to abort all the active jobs with a unique
barcode.
NOTE: If two Input source with the same Length different from zero are configured, the
following error message is displayed: The selected pattern is in conflict
with a previously added one.
NOTE: If Length is set to zero, any string starts the Job.
NOTE: If Length is set to a number (n) different from zero, and Significant Position is not
defined, any string with Length set to n starts the Job.