Atlas Copco FOCUS 61

Focus 61 User Guide Live Monitor
85 (118) 9839 0211 01 Edition 2.0
8 LIVE MONITOR
This functionality allows to see in real time the tightening results of the MWR connected with ToolsTalk
BLM.
It is possible to use the live monitor in two different way:
• From Connect menu, select Live monitor. No login is required.
In this case, the production tightenings are monitored. The same results displayed on the Focus 61
are shown by ToolsTalk BLM.
It is possible to open in read-only mode the page of the configuration of wrench, accessories, job
and device double-clicking the wrench, the accessory, the job or the device settings from the
Device area.
• From the toolbar, select the Live monitor icon ( ). The icon is available if the operator is
logged in.
In this case, it is possible to check if the Pset is configured in the right way.
Click Live Monitor. After executing a tightening with a linked MWR, the following screen shows:
A
General
Information
B
Torque
Status
C
Angle
Status
D
Tightening
Status
E
Angle
Result
F
Torque
Result
A
B
C
D
E
F