Atlas Copco FOCUS 61

Focus 61 User Guide Programming Focus 61
71 (118) 9839 0211 01 Edition 2.0
6.6.1 Adding a Stacklight
To add a Stacklight to the Focus 61, do the following:
1. In the Device Files area, right-click I/O Accessories. Then, click Add Stacklight.
In the Device area of the New Accessory dialog box, the Type drop-down list box is set to
Stacklight and it is unavailable.
2. In the Device area of the New Accessory dialog box, in the Available Stacklights drop-down list
box, select the serial number of the Stacklight to use.
3. In the Configuration area, configure the layout of the Stacklight. Refer to the following
paragraphs for more information.
NOTE: It is possible to configures the Stacklight, even if the MWR is linked but non
available.
4. On the upper-left corner of the New accessory dialog box, click Save.
A
Devices Files area
B
Device area
C
Configuration area
A
B
C