Atlas Copco FOCUS 61

User interfaces Focus 61 User Guide
9839 0211 01 Edition 2.0 28 (118)
4.9 Digital output
The Digital output allows to connect lamps or other devices that mange the output signal of the Focus by
using the Digital output connector (see the picture below).
• Output voltage: 24V
• Maximum current per signal: 100mA
• The signals marked A_ are switched via relay contacts
• Suitable for inductive loads
Focus 61
The connector supports cable diameter of Ø 6-8 mm.
The cable is not included and must be ordered and
welded with each pin’s connector.