Atlas Copco FOCUS 61

Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 36 (118)
5.4.1.4 Manage ToolsTalk BLM password
To set a password at the login of the ToolsTalk BLM software, do the following:
1. In the Windows 7 or later, right-click the ToolsTalk BML icon and select Run as administrator.
2. On the Menu bar, click Tools > Manage password.
3. In Set password dialog box, click Password required check mark.
4. In Password box, type the password.
5. In Confirm password box, type the password again.
6. On the lower-right corner of the Set password dialog box, click OK.
7. In the Notification message, click OK.
To change the set password at the login of the ToolsTalk BLM software, do the following:
1. In the Windows 7 or later, right-click the ToolsTalk BML icon and select Run as administrator.
2. On the Login dialog box, type the password, then click Login.
3. On the Menu bar, click Tools > Manage password.
4. In Set password dialog box, click Password required check mark.
5. In Password box, type the password.
6. In Confirm password box, type the password again.
7. On the lower-right corner of the Set password dialog box, click OK.
8. In the Notification message, click OK.
To delete the set password at the login of the ToolsTalk BLM software, do the following:
1. In the Windows 7 or later, right-click the ToolsTalk BML icon and select Run as administrator.
2. On the Login dialog box, type the password, then click Login.
3. On the Menu bar, click Tools > Manage password.
4. In Set password dialog box, click to remove the Password required check mark.
5. On the lower right corner of the Set password dialog box, click OK.
6. In the Notification message, click OK.
NOTE: Only the administrator of the computer where ToolsTalk BLM is installed, has the
right to add, change and disable the password.
If a user runs ToolsTalk BLM, Manage password is unavailable.