Atlas Copco FOCUS 61

Focus 61 User Guide Programming Focus 61
37 (118) 9839 0211 01 Edition 2.0
5.4.2 Toolbar
On the Toolbar, the following commands are displayed:
• Connect
Use Connect to connect ToolsTalk BLM software with the Focus 61.
• Reload
Use Reload to reload the data of the Focus 61 connected.
• Live Monitor
Use Live Monitor to open the Live Monitor function, showing in real time the tightening from
the connected wrenches.
NOTE: The tightenings (in real time) are displayed only one by one.
NOTE: Refer to the paragraph Live Monitor for further details.
• Results Viewer
Use Results Viewer to show the latest results stored by the Focus 61.
Refer to the paragraph Results Viewer for further details.
• SD card explorer
Use SD card explorer to read the files saved on the SD card. Refer to the paragraph SD card
explorer for further details.
• Traces viewer
Use Traces viewer to display the traces stored by the Focus 61.
Refer to the paragraph Traces viewer for further details.
• Disconnect
Use Disconnect to disconnect ToolsTalk BLM software from the Focus 61.
5.4.3 Status bar
The status bar shows the connection status between the Focus 61 and ToolsTalk BLM software.
It also shows the different connection type: offline, live monitor, and configuration.
When the connection between the Focus 61 and ToolsTalk BLM
software is stable, a green bullet followed by Connected represents the
connection status (see the figure on the right):
If the connection between the Focus 61 and ToolsTalk BLM
software is not found, a red bullet followed by Not Connected
represents the connection status (see the figure on the right):