Focus 61 User Guide Programming Focus 61
69 (118) 9839 0211 01 Edition 2.0
6.5.3 Setting identifiers in tightening results
Once identifiers have been configured, it is possible to decide if and which identifier should appear as a
part of result data set. The result identifiers can be configured at the bottom of the Identifier interface.
The result dataset gives three fields: Result Part 1, 2 and 3 that can be filled with following information:
Result source: select the signal between the following options:
• Station name – Select Station_IDN
• Job name – Select Job_IDN
• Step name – Select Job_Step_IDN
• Identifier – Select Writeable or Write_Once. In this case, the user can define which identifier type
to insert in that result part.
Type: select the identifier type between the following options:
• Job – The action linked to this type is to start a job.
• Step – The action linked to this type is to start a step (valid for job free only).
• First Job Condition – First additional condition to start a job.
• Second Job Condition – Second additional condition to start a job.
Significant position: the position of the characters that builds the substring that starts the Job
To Next Page
Loading...
