Atlas Copco FOCUS 61

Focus 61 User Guide Settings
99 (118) 9839 0211 01 Edition 2.0
12.2.6 Radio Frequencies Settings
In the Radio frequency settings section, it is possible to set
the radio frequency parameters of both the controller and
the wrench for each channel.
1. For each parameter, select the correct value by the
value drop down list. The parameters are:
• Power dBm: power of the controller/wrench
signal. It ranges from -20 to 5.
• Sensitivity: sensitivity of the controller/wrench.
It ranges from 2 (low sensitivity) to 8 (high
sensitivity).
• Lbt (listen before talk): interference level
beyond which transmission starts. It is enabled if
a Japanese channel is selected. It ranges from
-100 to 0.
2. From the Channel drop down list, select the
channel of interest.
3. To save the new values, click Set radio settings.
To load the default values for all the parameters, click the
Load default button.
NOTE: The controller/wrench parameters have default values that are specific for the selected
country.
NOTE: The value of the frequency near the Channel drop down list is updated only after the Set
radio settings button is clicked.
NOTE: The radio frequencies settings functionality is only accessible as Super User.