User interfaces Focus 61 User Guide
9839 0211 01 Edition 2.0 18 (118)
4 USER INTERFACES
4.1 Display
When the Focus 61 starts, the following screens show in sequence:
NOTE: The above screens refer to the Focus 61 start-up.
If no MWR is associated with any Station of the Focus 61, the yellow LED points out an ERROR (refer
to the paragraph LEDs for further details about LEDs):
NOTE: The status message 83 - Program missing indicates that the controller has not
been initialized with tightening programs yet. The status message will disappear when the MWR
is connected to the Focus 61.
If the MWR is associated with one Station of the Focus 61, but either the batteries level of the MWR is
too low or the MWR is out of the range of the Focus 61, the yellow LED points out an ERROR (refer to
the paragraph LEDs for further details about LEDs):
INIT
Focus 60%
Protocol 0%
To Next Page
Loading...
