Focus 61 User Guide Programming Focus 61
57 (118) 9839 0211 01 Edition 2.0
6.3.2 Pset parameters settings - Torque Limits
Below are the available torque limits:
• Cycle Start
Torque value from which the measurement of the tightening starts.
• Minimum torque and Maximum torque
Torque limits to get a positive result.
NOTE: If the Minimum Torque inserted is less than the 20% of the wrench maximum
torque, the wrench can be used, but a yellow dot appear beside the minimum torque box
and the following warning message will be displayed: “Minimum Torque must be equal
or higher than 20% of Wrench Maximum torque”.
The same message will be appear in the Live Monitor section.
To Next Page
Loading...
