Atlas Copco FOCUS 61 - Page 58

Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 58 (118)
In the Results Viewer, the Minimum Torque inserted less than the 20% of the wrench
maximum torque, is shown in the Low Range column with a tick in the box.
If Save button is selected with these settings the following warnings message is shown:
“Minimum Torque must be equal or higher than 20% of Wrench Maximum torque (20%
of Maximum torque [Nm]). Do You want to continue anyway?”
It is possible to continue with these settings, but the yellow dot with the warning message
will still remain indicated in the Torque limits setting.
• Target torque
Torque target value.
• Change screw at
Torque limit for which the screw or other parts could be damaged by the excessive torque applied.