Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 74 (118)
The lamp on the Stacklight is automatically coloured depending on the option selected.
3. Under the Setup button, select the AOP control check box.
4. Under the AOP control check box, click Set relay.
5. In the Set AOP relay for Lamp, select a relay from the drop down list.
6. Click Save.
6.6.1.2 Configuring Position
To configure the function of the button/key-switch, installed on the Stacklight:
1. In Input section, select the Mounted check box for Position A / B
2. In the drop-down list box under the Mounted check box, select one of the following element:
• Button
• Key switch two positions
• Key switch three positions.
3. Below the Mount check box, click the Setup button.
4. In the Setup of Position A / B dialog box, select an event from the Event action drop down list. If
Abort job or Start job are selected, the Action parameters drop down list is available. From it,
select the Job to use as event.
If no Jobs are configured, the Action parameters drop down list and the Add button are
unavailable.
5. On the right side of the Setup of Position A / B dialog box, click Add.
6. On the lower-right corner of the Setup of Position A / B dialog box, click Save.
In the Setup of position dialog box, a tab is shown for each function of the selected Stacklight element:
• Button: button hit, button released.
• Key switch two positions: key right switched, key switched off.
• Key switch three positions: key right switched, key right switched off, key left switched, key
left switched off.
Repeat the configuration of all the tab in the Setup of position dialog box.
To remove an Event Action:
1. In the Setup of position dialog box, select an Event action in the table.
2. On the right side of the Setup of position dialog box, click Remove.
3. On the lower-right corner of the Setup dialog box, click Save.
To change the sorting of the Event Actions table:
1. Select a row of the table.
To Next Page
Loading...
