Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 38 (118)
6 PROGRAMMING Focus 61
The Focus 61 can manage one or two separate stations (at maximum).
The stations are virtual, used by the software to let the device manage the job(s) of the operators working,
for instance, of the two sides of the same assembly area (in the case of the Focus 61).
For each station, the sequence of operations that the operator must execute is defined into one or more
Jobs. Each Job is a set of Pset, which is the tightening program loaded on the MWR.
To Next Page
Loading...
