Atlas Copco FOCUS 61

Focus 61 User Guide User interfaces
19 (118) 9839 0211 01 Edition 2.0
Associate the MWR with a Station of the Focus 61. After few seconds, the Focus 61 shows the data of the
ongoing tightening operation on the MWR (refer to the following picture):
A
Batch counter
Number of the current tightening over the job step total tightenings.
B
Status
Result of tightening operation of the operating MWR.
NOTE: Refer to the paragraph Executing tightening operations for
further details.
C
Angle
Maximum angle measured during the tightening phase.
D
Torque click
Click-point measured during tightening phase.
E
Torque peak
Maximum torque measured during tightening phase.
F
MWR serial number
Serial number of the MWR that is working.
4.2 Keyboard
Use the keyboard to browse the Focus 61 menu and to change
the info screens:
• OK ( )
Middle button under the display. It changes the settings of the device.
• Down ( )
Left button under the display. It slides down the fields of the settings and decreases value in
settings menu.
• Up ( )
Right button under the display. It slides up the fields of the settings and increases value in settings
menu.
A
B
C
D
E
F