Atlas Copco FOCUS 61 - Page 20

User interfaces Focus 61 User Guide
9839 0211 01 Edition 2.0 20 (118)
Below is the tree view that shows a hierarchical structure of the Focus 61 menu.
Press OK for entering the tree structure.
Then press UP and/or DOWN for browsing the Focus 61 menu.
config
general
base address
Address for the radio communication
country
Country of the radio frequencies in use
user id
User code ***
language
Language of the controller
unit
Unit of measurement
back
Exit the General menu
RS232
Data rate
Parameter of the serial port
Stop bits
Parameter of the serial port
Parity
Parameter of the serial port
Termin. char
Parameter for the serial communication
Start char
Parameter for the serial communication
Ignore char
Parameter for the serial communication
5V supply
Power supply enablement for barcode scanner
back
Exit the RS232 menu
security
menu access
Menu access level
back
Exit the Security menu
display
contrast
Contrast level of the display
brightness
Brightness of the display
back
Exit the Display menu
transceiver
datarate
Baud rate of the radio signal
channel
Channel used for the radio communication
Power, dBm
Power of the radio signal
sensitivity
Sensitivity of the radio
LBT
Listen before talk
back
Exit the transceiver menu
options
ssc filter
Dataset filter settings
time sync
Enable/disable time synchronization using ToolsNet time
stamp
back
Exit the options menu
Log subscr
SD
Log level for the main board
MP Port
Log level for the MPC board
back
Exit the Log subscr menu
LUA
Interpreter
auto restart
LUA restart delay
back
Exit the LUA interpreter
tools
monitorport
Enablement of the serial port log
back
Exit the tools menu
back
Exit the Config menu