Focus 61 User Guide Programming Focus 61
75 (118) 9839 0211 01 Edition 2.0
2. On the right side of the Setup of position dialog box, click the Up/Down arrow button to move
up /down the selected row.
3. On the lower-right corner of the Setup dialog box, click Save.
6.6.1.3 Configuring Digital input
To configure the signals sent to the Stacklight.
1. In the Digital inputs section, select the Mounted check box for Input 1 / 2.
2. Below the Mounted check box, click the Setup button.
3. In the Setup of Input 1 / 2 dialog box, select an event from the Event actions drop down list.
If Abort job or Start job are selected, the Action parameters drop down list is available. From
it, select the Job to use as event.
If no Jobs are configured, the Action parameters drop down list and the Add button are
unavailable.
4. On the right side of the Setup of Input 1 / 2 dialog box, click Add.
5. On the lower right corner of the Setup of Input 1 / 2 dialog box, click Save.
In the Setup of Input dialog box, a tab is shown for:
• Digital input on.
• Digital input off.
Repeat the configuration of all the tab in the Setup of input dialog box.
To remove an Event Action:
1. In the Setup of input dialog box, select and Event action in the table.
2. On the right side of the Setup of input dialog box, click Remove.
3. On the lower-right corner of the Setup dialog box, click Save.
To change the sorting of the Event Actions table:
1. Select a row of the table.
2. On the right side of the Setup of input dialog box, click the Up/Down arrow button to move up
/down the selected row.
3. On the lower-right corner of the Setup dialog box, click Save.
6.6.1.4 Configuring Buzzer
To configure the buzzer functionality, if the behaviour of the buzzer is related to an Event (for example
tightening OK):
To Next Page
Loading...
