Results Viewer Focus 61 User Guide
9839 0211 01 Edition 2.0 88 (118)
9 RESULTS VIEWER
The Results Viewer icon shows a list of the tightening results of all MWR connected
with ToolsTalk BLM.
To configure the results viewer settings, do the following:
1. In the Device Files area, click Results Viewer.
2. On the left side of the Filters selection dialog box, select the results to show.
3. In the Optional filters area, set Date/time filter.
In the Date/Time box, click the drop-down list box and select either Equal or Between. Then
click Add.
NOTE: Equal option filters results measured in a specified day.
Between option filters results depending on a defined time interval
4. In the Optional filters box, set Wrench Status filter.
In the Wrench Status box, click the Wrench Status drop-down list box and select the necessary
result status. Then click Add.
5. In the Optional filters box, set Wrench Serial filter.
In the Wrench Serial box, click equal to drop-down list box to show the Serial numbers of the
wrenches connected with one of the two Stations. Then select one Wrench Serial.
It is also possible to keep ANY on the equal to drop-down list box. Then, type the Serial
number of the necessary wrench into the Starts with text box. Partial matching is supported:
wrenches whose serial number match the text string will be shown
After configuring the serial number of the wrench, click Add.
6. In the Filters selection dialog box, the Summary box summarizes the Date/time filter, Wrench
Status filter, and Wrench Serial filter set in the Optional filters box.
NOTE: Remove (placed on the right side of the Summary box) removes the filters
inserted in the Summary area singularly.
Clear (placed under Remove) removes all of the filters inserted in the Summary box
at the same time.
At the end of the configuration of the Filters selection dialog box, click OK.
To Next Page
Loading...
