Focus 61 User Guide Programming Focus 61
41 (118) 9839 0211 01 Edition 2.0
6.2 Linking the MWR with Station(s)
It is possible to link up to 10 MWR with a Focus 61, divided into the two
Stations.
Selecting Wrenches in the Device files tree, all the wrenches are
displayed, divided in the following sections:
• Linked Wrenches: list of all the available wrenches, which are
already linked to the controller and ready to be used.
• Busy Wrenches: list of all the MWR, linked to another
Controller. These wrenches cannot be linked to your Controller.
• Available Wrenches: list of all the powered on MWR, not linked
to any Controller. These wrenches can be assigned to your
Controller.
For each MWR the following information are displayed:
• Wrench Type
MWR model
• Serial Number
Serial number marked on the MWR
• Base SN
Serial number of the Focus 61
• FW
Firmware version loaded on the MWR
• Minimum Torque
Minimum torque values for the MWR- TA or MWR- T model
To Next Page
Loading...
