Atlas Copco FOCUS 61 - Page 42

Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 42 (118)
• Maximum Torque
Maximum torque values for the MWR- TA or MWR- T model
• Overload Torque
Maximum overload torque for the MWR- TA or MWR- T model
• Last Seen
Time in seconds passed from the last pin send by the MWR to the controller (Keep alive mode)
NOTE: This box is highlighted by different colors depending on the time of connection failure.
• RSSI Base
Received Signal Strenght Indication (indicated in dBm)
• RSSI Device
Received Signal Strenght Indication of the Device (indicated in dBm)
• Battery status
Green ( ) → Battery charge ok
Red ( ) → Battery charge low
Empty ( ) → MWR not available (but already linked)
• In Cradle
Selected if the MWR is on the MWR Charging Cradle
• Overload
Selected if the MWR has been overloaded.
• Calibration required
Selected if the calibration date is expired.
• Service required
Selected if the maximum number of the tightenings has been exceeded. The maximum number of
tightenings is set to 285000.
To update both the list of Busy Wrenches and the list of Available Wrenches, click Refresh: