Focus 61 User Guide Programming Focus 61
43 (118) 9839 0211 01 Edition 2.0
To link a MWR with a Station, do the following:
• Drag one of the available MWR to the Wrench menu of the Station (refer to the figure below):
On the linked MWR, the yellow LEDs are active. (for further details about MWR LEDs, refer to
the MWR and MWR Charging Cradle User Guide).
When a wrench is dragged on the Wrench menu, a Group is created.
It is possible to add other wrenches to a Group only if the wrench type and range are the same of
the wrench that created the Group. Each Group contains at most three wrenches per Group.
It is also possible to swap a wrench linked to a Group with a wrench in the Available wrenches
list. Drag the available wrench on the wrench linked to the group. The replaced wrench is added to
the Available wrenches list.
To Next Page
Loading...
