Live Monitor Focus 61 User Guide
9839 0211 01 Edition 2.0 86 (118)
In the screen above the example of the MWR- TA is shown.
For MWR- T, the section of angle is not shown.
For the MWR- S only the OK result is displayed when a click is effectuated.
The Results Monitor dialog box shows the following information:
• Wrench serial number
Serial number of the MWR.
• #
Result ID.
• IDN1: IDN2: IDN3:
Result Identifier defined in the Job.
NOTE: The Result Identifier is only visible in case of a running sequence / Job on the MWR
and when it was previously configured. In any other case a "-" character will be shown.
• Export Results
This option exports in an Excel file the results displayed in a tightenings session.
• Batch Size, Max NOK
Job Step Parameters for the MWR.
• OK, NOK
Number of tightening operations with OK and Not OK results.
• Torque result and Angle Result (left side of the screen)
Peak and click torque/angle values of the last tightening operation.
The boxes are green colored if the torque/angle peaks are between the minimum and maximum
values defined in the MWR Pset; otherwise they are red colored.
• Torque Status and Angle Status (right side of the screen)
This box shows the status and the limits defined in the MWR Pset.
The status can be:
- Waiting…: Live results monitor open, but no results available yet.
- Low: Torque/Angle lower than the minimum value.
- OK: Torque/Angle within the limits.
- High: Torque/Angle higher than the maximum value.
• Status
Overall status of the tightening operation.
Refer to the paragraph Executing Tightening Operations for further details about the code shown
here.
The box is green if the Status is OK, yellow if the MWR is locked, red if the Status is Not OK.
To Next Page
Loading...
