Atlas Copco FOCUS 61 - Page 64

Programming Focus 61 Focus 61 User Guide
9839 0211 01 Edition 2.0 64 (118)
• Max NOK
For each tightening of the batch, it specifies how many times the operator can execute a test with
Not OK result.
For instance, if it is set to 2, the operator can repeat two times a wrong tightening; at the 3
rd
Not
OK, the batch stops and the Job continues or aborts depending from the NOK Strategy parameter
defined in the Job.
• Infinite NOK
Selecting Infinitive NOK option specifies that the operator can execute a test with Not OK result
infinitely. This option disables Max NOK setting.
• Timeout [s]
Maximum time (in seconds) to start the Step from the moment the MWR is ready to start.
NOTE: The maximum permitted number of Steps (per Job) is equal to 100.
The Steps List area shows all of the Steps defined.
NOTE: To modify a step, double-click the parameter which you want to change (e.g. Batch Size).
NOTE: It is MANDATORY to disconnect ToolsTalk BLM to start a Job on the Focus 61
Controller.