Atlas Copco FOCUS 61 - Page 116

Appendix B Focus 61 Quick Guide
9839 0211 01 Edition 2.0 116 (118)
19 APPENDIX B – ERROR CODE AOP
In the following table, the list of the errors code sent in MID 0071:
ERROR CODE
DESCRIPTION
510
Station is not ready
520
Wrench Group is not ready
540
Wrench is not operational
542
Wrench could not be initialized
543
Tool Ping timed Out
544
Wrench CRC Mismatch/Error
545
Wrench Firmware Error
546
Wrench Error Calibration date
547
Wrench Error Calibration Interval
548
Wrench Error Overload
549
Wrench Error Calibration Offset (Cradle)
550
Wrench Hardware error
551
Wrench Error Battery (Battery Low)
552
Wrench voltage Drop detected
553
Wrench Error Restart detected
554
Wrench Error -> Put into the cradle
555
Wrench requires Service
556
Wrench is linked to a service station (Service Link)
557
Wrench Error (Calibration date, Calibration Interval, Overload)
558
Mechanical parts replacement