Set Up and Maintenance
122 9836 3521 01
Here you can select which predefined reporter settings that will be used for the Screen and Trace reporter.
Note that it is not possible to leave these selections blank.
Note that this dialog is only displayed if you have placed more than one file in the special directory for the
reporter in question. By default, this dialog is not displayed.
Press Next >> to display the last wizard dialog:
Mark boxes if you want a Checklist on printer or Checklist on file. In the latter case you can specify a
filename. The checklist will contain a list of activities that you should perform after that the initial setup is
created.
Pressing Finish will make the wizard create the new setup based on the information you have specified.
The following items will be included in the setup created:
To Next Page
Loading...
Need help?
General
