Tightening
358 9836 3521 01
The bolt is ordered to
terminate
The bolt is ordered to
start repair
The bolt is ordered to
terminate
The bolt is ready with repair
The terminate
sequence is
done
There is no more to
execute and the station
orders the bolt to finish
The bolt is ready with repair when:
ï‚· The bolt reaches CE step.
ï‚· The bolt reaches RE step and no Repair with step is configured.
ï‚· All steps from Repair with step to the last step in the failing synchronization interval has been run.
The bolt failed running one of the steps in the failing synchronization interval. This causes an immediate
First try evaluation that affects all not terminated bolts in the station. If the evaluated reject action is Retry
the bolt reenters Running Repair.
If an initial repair ends with RE step and no repair step is configured cycle execution resumes at the step
where the Retry was ordered. Next step when running normal is the step after the step where Retry was
ordered. When another bolt fails in its Failing synchronization interval and the action determined by the
station is Retry or Terminate the steps run by the OK bolt is configured in the step where the retry was
ordered.
To Next Page
Loading...
Need help?
General
