Tightening
360 9836 3521 01
Failing
synchronization
interval
2 Bolt transfer from state
RUNNING REPAIR to
RUNNING NORMAL
1 Bolt transfer from state
RUNNING NORMAL to
RUNNING REPAIR
3 Bolt transfer from state
RUNNING NORMAL to
RUNNING TERMINATE
4 End of cycle at RE.
Monitoring checks according to
step 8. Bolt doesn‟t participate
in cycle RM as it is Terminated
Bolt 2 runs OK, but is ordered to Retry and Terminate when bolt 1 fails:
2 Bolt transfer from state RUNNING
REPAIR to RUNNING NORMAL when
station starts step 6 on Bolt 1.
1 Bolt transfer from state
RUNNING NORMAL to
RUNNING REPAIR
3 Bolt ordered to Terminate, no
Terminate step defined in step 11. Ready
immediately and keeps status OKR.
To Next Page
Loading...
Need help?
General
