Tightening
9836 3521 01 393
Final torque too low during monitoring on second buffer
Angle too high during monitoring on second buffer
Angle too low during monitoring on second buffer
Monitoring: Overflow in second recording buffer. See description of parameter
"Allow monitoring buffer overrun" in Program Settings.
Min Torque restriction exceeded
Gradient restriction, high limit exceeded
Gradient restriction, low limit exceeded
Yield angle, high limit exceeded
Yield angle, low limit exceeded
This is bit is set if any error bit(s) in the range 96 . 127 are set and only the first 12
bytes are included. That is, Type in the reporter is set to "I12".
Delta torque high alarm from check
Delta torque low alarm from check
Low spot torque high alarm from check
Low spot torque low alarm from check
Backlash angle high alarm from check
Backlash angle low alarm from check
Zero crossing high alarm from check
Zero crossing low alarm from check
Step input not OK alarm from check
To Next Page
Loading...
Need help?
General
