Basic Functions
9836 3521 01 55
To edit a setup when Disconnected
This is how you start up when you want to check or edit a setup, without connecting to a running system:
1. From the File menu select Open, or from the welcome screen, select Open an existing setup
2. In presented file list, select an existing setup
If you want to create a completely new setup, select New from the File menu or Create a new setup from
the welcome screen.
To connect to the current target system
This is how you start up ToolsTalk PowerMACS when you want to connect to the current target system
(that is the system ToolsTalk PowerMACS was most recently connected to).
Using the welcome screen:
1. Make sure your console computer is connected to the network of the system in question.
2. Press the Connect to the current target system to connect.
Using the regular interface:
1. Make sure your console computer is connected to the network of the system in question.
2. Press the Connect button on the toolbar.
To connect to a specified system
This is how you start up ToolsTalk PowerMACS when you wan to connect to a specified target system.
Using the welcome screen:
1. Make sure your console computer is connected to the network of the system in question.
2. Press the Connect to system..
3. From the Select Target System window select the system.
Using the regular interface:
1. Make sure your console computer is connected to the network of the system in question.
2. Press the down-arrow on the Connect toolbar button and select Select target system...
3. From the Select Target System window select the system.
If you want to download a setup to the target fist make sure it is loaded in ToolsTalk PowerMACS, either
by reading it from disk (menu: File – Open) or by Creating a new system using the Set Up Wizard (menu:
File – New).
Connecting to a system
When ToolsTalk PowerMACS connects to a system over the network the following can occur:
To Next Page
Loading...
