Peripheral Devices
602 9836 3521 01
The first found step defines the control strategy of the program.
Defines Control Strategy as
DT - Run until Dyna-TorkTM
DT2 - Run until Dyna-TorkTM, method 2
DT3 - Run until Dyna-TorkTM, method 3
T - Run until Torque
TC - Run until Torque with Current Control
AO - Run until Angle with overshoot compensation
A - Run until Angle
PA - Run until Projected angle
TA – Run Torque-Angle with no stop
Depending on the outcome of the Monitoring result and the Control strategy of the used program the result
for each bolt is indicated according to the following schemas:
Torque Control strategy:
If a REHIT is detected (see below for how) then the Yellow + Red outputs are set.
Angle Control strategy:
If a REHIT is detected (see below for how) then the Yellow + Red outputs are set.
To Next Page
Loading...
Need help?
General
