Appendix
9836 3521 01 637
ToolsNet: Station number is missing in Cycle data
ToolsNet: Start time is missing in Cycle data
ToolsNet: Station status is missing in Cycle data
ToolsNet: Bolt number is missing in Cycle data
ToolsNet: Bolt status is missing in Cycle data
ToolsNet: Bolt data for bolt no: %d is missing in Cycle data
ToolsNet: Operation mode for bolt no: %d is missing in Cycle
data
ToolsNet: Wrong format for torque and/or angle factors
ToolsNet: Reported data for %d of %d optional variables for
Bolt: %d
ToolsNet: Reported data for %d of %d Bolts
ToolsNet: Cycle data is corrupt, not possible to send, Info = %d
SPC: Variable does not exist (Bolt: %d, StepNo: %d, Var: %d)
SPC: One out check failed
SPC: End gather check failed
SPC: Mid gather check failed
SPC: Seven above check failed
SPC: Seven below check failed
SPC: Seven up check failed
SPC: Seven down check failed
SPC: Cp limit check failed
SPC: Cpk limit check failed
SPC: Cam limit check failed
SPC: Sub group size must be > 0 (NoSttSgSave=%d
Sgsize=%d NoSubSgSave=%d)
SPC: Ref. to free area is corrupt (FreeMem=%d
SubgrpBase=%d NoSubSgSave=%d)
SPC: SPC data structure corrupt, pos %d, idx: %d, %d
SPC: Too many variables for spindle %d
Illegal link message rec. (device %d, type %d, info %d)
Send failed. Not possible to correct with retransm. (port %d, info
%d)
To Next Page
Loading...
